3D Puff Heat Transfer Vinyl SHEETS HTV 20" Donkey Craft Vinyl

Donkey Puff Heat Transfer Vinyl

PLEASE NOTE: ***This product is a 3D Puff VINYL SHEET. Cutting and design services are NOT included.***

Please consider that the black puff vinyl will turn dark gray after puffing.

SPECIFICATION

Thickness: 130 Micron (before), 500 Micron (after)

Temperature: 292°F~310°F - Please make sure to test the temperature first due to the heat sensitivity of the material. Please start from a low temperature and gradually increase the temperature by 5 degrees if the puffing is not working well.

Pressure: Medium

Time: 8~10 Seconds

Cutting Setting: 45-degree cut

Apply to Cotton, Uncoated Polyester, and Cotton-Polyester Blends excluding Nylon

DESCRIPTION

- Puff Heat Transfer Vinyl: Cuttable vinyl with protective carrier and hot melt backing

- Soft and Fluffy Puff effect is activated upon heat press and removal or protective film

- Be aware of the result that 2mm or smaller space will disappear when the puff is activated.

-Do not layer HTV

APPLICATION

***We do not recommend using any household irons or Cricut Easy Press because the transfer needs accurate temperature and even pressure.

- Plotter cut the wanted design on the hot melt layer (Glossy Side up)

- Mirror Cut

- Weed the unwanted material

- Place it on the fabric

- Press at medium pressure

- Remove the protective carrier at Hot Peel

**** Please, make a small test cut before making your project